Safety Data Sheet

AQUASET® Safety Data Sheet

Synonym: Sodium montmorillonite · Absorbent for binding, plasticizing and solidifying aqueous liquids.

Document FTL-080-0001 Revision 5 Revised March 22, 2022 Format GHS / 16-section
First page of the AQUASET® Safety Data Sheet

Official SDS · 7 pages · PDF

The linked PDF (Revision 5) is the authoritative document. The text below reproduces its contents for accessibility and reference. If anything differs, rely on the PDF, and confirm the revision date is current (within 3 years) before relying on this sheet.

1. Identification

Product identifier
AQUASET®
Synonyms
Sodium montmorillonite
Recommended use
An absorbent used for binding, plasticizing and absorbing/solidifying aqueous liquids.
Recommended restrictions
None known.
Manufacturer
Fluid Tech LLC, 146 Industrial Park Road, Sweetwater, TN 37874, USA
Telephone
(423) 271-6505 · Fax (800) 994-8561
Emergency phone
(865) 809-9995
Website / email
www.fluidtechllc.com · info@fluidtechllc.com

2. Hazard(s) Identification

Signal word: Danger

Hazard classification: Carcinogenicity (Category 1A); Specific Target Organ Toxicity – Repeated Exposure (Category 1)

Hazard statements: May cause cancer. Causes damage to organs through prolonged or repeated exposure.

Precautionary statements

Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust. Wash face, hands and any exposed skin thoroughly after handling. Do not eat, drink or smoke when using this product.
Response
If exposed or concerned: get medical advice/attention. Get medical attention/advice if you feel unwell.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations.
Hazards not otherwise classified
May cause eye and respiratory irritation.

3. Composition / Information on Ingredients

SubstanceCAS numberPercent
Crystalline silica, quartz14808-60-7≤ 6%

4. First-Aid Measures

Inhalation
If inhaled, remove to a dust-free area. Get medical attention if respiratory irritation develops or if breathing becomes difficult. Inhalation may aggravate existing respiratory illness.
Eyes
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes and get medical attention if irritation persists.
Skin
Wash with soap and water. Seek medical attention if irritation persists.
Ingestion
Do not induce vomiting. First-aid measures not normally required.
Notes to physician
Treat symptomatically.

5. Fire-Fighting Measures

Suitable extinguishing media
Product is non-combustible. All standard fire-fighting media may be used.
Unsuitable extinguishing media
None.
Specific exposure hazards
None known. Product is not combustible.
Protective equipment for firefighters
None for product. Wear self-contained breathing apparatus (SCBA) and full protective gear.
Precautions for firefighters
Caution: slippery when wet.
NFPA ratings
Health: 1 · Flammability: 0 · Reactivity: 0

6. Accidental Release Measures

Personal precautions
Use appropriate protective equipment. Avoid creating and breathing dust. Prevent further leakage or spillage if safe to do so.
Environmental precautions
No special environmental precautions required.
Cleaning / absorption
Prevent further leakage or spillage if safe to do so. Avoid generating dust. Collect using an appropriate dustless method. Dispose in landfill according to local, state and federal regulations.

7. Handling and Storage

Precautions for safe handling
This product contains quartz which may become airborne. Avoid breathing dust and creating dusty conditions. Promptly clean up spills. Use only with adequate ventilation to keep exposure below recommended limits. Wear a NIOSH/MSHA (or European Standard EN 149, or equivalent) respirator certified for silica-bearing dust. Material is slippery when wet.
Conditions for safe storage
Use good housekeeping to prevent dust accumulation. Close container when not in use. Do not reuse empty container. Do not allow water/moisture to contact the product until time of use, to preserve product utility.

8. Exposure Controls / Personal Protection

SubstanceCAS numberACGIH TLV-TWAOSHA PEL-TWA*
Crystalline silica, quartz14808-60-70.025 mg/m³10 mg/m³ ÷ (%SiO₂ + 2)

* More restrictive exposure limits may be enforced by some states, agencies, or other authorities.

Engineering controls
Use approved industrial ventilation and local exhaust as required to maintain exposures below applicable limits.
Respiratory protection
Not normally needed. If significant exposures exceeding the occupational exposure limit are possible, use a NIOSH/MSHA respirator approved for silica-bearing dust.
Hand protection
Standard work gloves.
Skin protection
Wear clothing appropriate for the work environment. Launder dusty clothing before reuse; avoid creating dust when removing or laundering clothing.
Eye protection
Wear safety glasses or goggles to protect against exposure.

9. Physical and Chemical Properties

Physical state
Granular solid
Color
Light tan to gray
Odor
Odorless
pH
8 – 10 (5% aqueous solution)
Bulk density
60 – 66 lbs/ft³
Solubility (water)
Insoluble; forms colloidal suspension
Viscosity (dynamic @ 20 °C)
3.5 – 12.5 (6% aqueous suspension)
Specific gravity
2.45 – 2.55
Percent volatile
0% (estimated)
Flash point / flammability
Not applicable

Melting/boiling point, evaporation rate, vapor pressure/density, and flammability/explosive limits: not applicable. Relative density and auto-ignition/decomposition temperature: not determined. See PDF for the complete property table.

10. Stability and Reactivity

Reactivity
Non-reactive.
Chemical stability
Stable.
Hazardous reactions
Hydrofluoric acid.
Conditions to avoid
None.
Incompatible materials
Hydrofluoric acid.
Hazardous decomposition products
Silica will dissolve in hydrofluoric acid and produce a corrosive gas — silicon tetrafluoride.

11. Toxicological Information

Principal route of exposure
Eye or skin contact, inhalation.
Inhalation
Inhaled crystalline silica in the form of quartz from occupational sources is carcinogenic to humans (IARC, Group 1).
Skin contact
May cause skin irritation due to drying.
Eye contact
May cause mechanical eye irritation.
Aggravated medical conditions
Individuals with respiratory disease (including but not limited to asthma and bronchitis) or subject to eye irritation should not be exposed to respirable quartz-bearing dust.

Chronic effects and carcinogenicity

Silicosis: Excessive inhalation of respirable crystalline silica dust may cause a progressive, disabling, and sometimes-fatal lung disease called silicosis (symptoms include cough, shortness of breath, wheezing, non-specific chest illness, and reduced pulmonary function), exacerbated by smoking; individuals with silicosis are predisposed to develop tuberculosis.

Cancer status: IARC (1997) concludes there is sufficient evidence in humans for carcinogenicity of inhaled crystalline silica from occupational sources (Group 1). NTP classifies respirable crystalline silica as "Known to be a human carcinogen." ACGIH classifies crystalline silica, quartz, as a suspected human carcinogen (A2).

12. Ecological Information

Mobility, persistence/degradability, bio-accumulation, and acute aquatic (fish, crustacean, algae) toxicity: not determined. Other information: not applicable.

13. Disposal Considerations

Disposal method
If the product becomes a waste, dispose in a licensed landfill according to federal, state and local regulations.
Contaminated packaging
Follow all applicable national or local regulations.

14. Transport Information

Land (DOT / TDG / ADR)
Not regulated as dangerous goods.
Air (ICAO / IATA)
Not regulated as dangerous goods.
Sea (IMDG)
Not regulated as dangerous goods.
Labels
None.

15. Regulatory Information

United States

TSCA inventory
All components listed on inventory or exempt.
SARA (311, 312) hazard class
Chronic health hazard.
SARA (313) chemicals
Does not contain a toxic chemical for routine annual "Toxic Chemical Release Reporting" under Section 313 (40 CFR 372).
RCRA hazardous waste
If the product becomes a waste, it does NOT meet the criteria of a hazardous waste as defined by the US EPA.
California Proposition 65
This product contains crystalline silica (respirable), a substance known to the State of California to cause cancer.

Canada

DSL inventory
All components listed on inventory or exempt.
WHMIS hazard class
Contains crystalline silica (respirable); classified as Class D, Division 2, Subdivision A.

16. Other Information

Issue date
May 15, 2015
Revision date
March 22, 2022
Version
05

Revision history

  • Revision 1 — Composition/Information on Ingredients: ingredients
  • Revision 2 — Physical & Chemical Properties; Regulatory Information (US); Hazard Identification: pictograms
  • Revision 3 — Change of company address
  • Revision 4 — Change of format
  • Revision 5 — Audit: additional format modifications

Disclaimer

The information in this sheet was written based on the best knowledge and experience currently available. The information given is correct to the best of our knowledge, information and belief at the date of its revision and publication. However, the manufacturer makes no representation, warranty or guarantee as to its accuracy, reliability or completeness, nor assumes any liability for its use. It is the user's responsibility to confirm in advance that the information is current, applicable and suitable to their circumstances for each particular use. Please call for document accuracy if the revision date has exceeded 3 years.

Download official PDF (Rev 5)